Can the Anker SOLIX C300 DC Run a Gas Furnace Blower?
❌ No — the Anker SOLIX C300 DC is not a safe match for a Gas Furnace Blower. This is a DC-only unit with no AC inverter, so it cannot power any standard AC-plug appliance.
The Checks, One by One
| Check | Result | Detail |
|---|---|---|
| AC inverter | ❌ fail | This is a DC-only unit with no AC inverter, so it cannot power any standard AC-plug appliance. |
Side by Side
| Spec | Anker SOLIX C300 DC | Gas Furnace Blower needs |
|---|---|---|
| Continuous output | Not confirmed | 600W |
| Startup surge | Not confirmed | 1500W |
| Battery capacity | 288Wh | — |
| Inverter | None (DC-only) | Pure sine wave required |
About This Appliance
Only the blower, igniter and controls are electrical on a gas furnace — the heat itself is gas. ECM/variable-speed blowers draw considerably less than a PSC motor and ramp rather than hard-starting, so they are the easier case. Published generic figures for this appliance range from 375W to 1,500W, which is why a single named reference configuration is used instead.
Other Units With This Appliance
Methodology
Verdict computed from this project's verified entity data using the same gates as its use-case scoring: waveform requirement first (an unconfirmed inverter type fails rather than passing), then continuous watts, then startup surge, then runtime at a 75% AC-inverter efficiency factor. Entity specs verified 2026-10-25; appliance figure from Reference configuration: a standard 1/2 HP residential gas furnace blower (PSC motor). 1/2 HP is 373W of mechanical output, which at the ~60% efficiency typical of a PSC blower motor is about 600W electrical. Surge of 1,500W is DERIVED at 2.5x running, the multiplier this dataset already uses for fan and compressor motors (window AC 800W -> 2,010W)..
Full Anker SOLIX C300 DC specs → · Runtime calculator → · Surge calculator →